Difference between revisions of "Log-periodic antenna"
(→Antenna setup) |
(→Receiver) |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 6: | Line 6: | ||
* Pole + ground foot | * Pole + ground foot | ||
* guy wire | * guy wire | ||
| − | * star pickets | + | * star pickets (min 3) |
* receiver | * receiver | ||
* cable antenna-receiver | * cable antenna-receiver | ||
| + | * 4x D-cell batteries | ||
Tools: | Tools: | ||
| − | * PH2 | + | * PH2 screwdriver |
* metric socket set | * metric socket set | ||
| − | * ... | + | * hammer |
| − | + | * knot tying skills... ask Ellie :) | |
= Receiver = | = Receiver = | ||
| Line 20: | Line 21: | ||
Instructions: [[Media:UHF_receiver_operation_manual.pdf]] | Instructions: [[Media:UHF_receiver_operation_manual.pdf]] | ||
| + | Time to set for the login start: | ||
| + | 2020-12-05T17:26:00 (UTC) | ||
| + | The receiver will log for 5 minutes. | ||
= Antenna setup = | = Antenna setup = | ||
| − | Follow instructions from the antenna manual, being careful not to lose | + | * Follow instructions from the antenna manual, being careful not to lose nuts and bolts! |
| − | + | * Before attaching the choke (coil thing at the large end), check using voltmeter there is no electrical short between the 2 sides of the antenna. | |
| − | Before attaching the | + | * Cable tie RF cable to the beam, making sure it remains aligned with the beam. |
| + | * Do not tighten coax connectors too much, just finger tight. | ||
| − | + | [[File:antenna_cable_feeding.jpg|400px]] | |
Latest revision as of 14:59, 4 December 2020
pre-requisite
Things required:
- Antenna box
- Pole + ground foot
- guy wire
- star pickets (min 3)
- receiver
- cable antenna-receiver
- 4x D-cell batteries
Tools:
- PH2 screwdriver
- metric socket set
- hammer
- knot tying skills... ask Ellie :)
Receiver
Instructions: Media:UHF_receiver_operation_manual.pdf
Time to set for the login start: 2020-12-05T17:26:00 (UTC)
The receiver will log for 5 minutes.
Antenna setup
- Follow instructions from the antenna manual, being careful not to lose nuts and bolts!
- Before attaching the choke (coil thing at the large end), check using voltmeter there is no electrical short between the 2 sides of the antenna.
- Cable tie RF cable to the beam, making sure it remains aligned with the beam.
- Do not tighten coax connectors too much, just finger tight.
