Replacing the Hard Drives
Contents
Physical drive swap
Firstly, for all cameras, ensure hard drives are not mounted (i.e. "data1"). In a terminal, check:
$ df -h
If they appear, they will need to be unmounted and any enclosures disabled:
$ umount /data1 $ /opt/dfn-software/disable_ext-hd.py # this is for DFN-EXT and DFNSMALL only, not necessary for kits.
Depending on your camera model, the drives can be swapped as follows:
DFN EXT
Kit Cameras
Your camera model has one hard drive that hangs from a plastic mount.
- Open lid using a large flat-head screwdriver.
- Remove short cables from camera (most likely just the USB connector, possibly also the trigger cable and power.
- Unscrew 4 small philips-head screws that hold the HDD.
- Remove SATA cable from HDD.
- Remove the 4 extension pins from the old drive and screw them into the new HDD.
- Reconnect SATA cable to new HDD.
- Reattach to plastic mount using the 4 philips-head screws.
- Reconnect cables removed from camera.
- Before closing lid, check that the HDD SATA cable is properly attached; check camera trigger cable, power cable, LC shutter cables and USB cable are all properly connected.
- Close lid. (suggested to run test procedures before fully tightening lid)
DFN Small
Your camera model should have the hard drive enclosure mounted on the door.
- Data1 can be removed by simply opening the outer enclosure door.
- Data2 requires the enclosure to be removed to access.
- remove screws at the base of the hard drive enclosure. (Keep them safe, they are easy to get lost!)
- swap the drive
- replace the enclosure ensuring all screws are tight. Wobbling when in use could affect images.
Subsequent procedures
GUI
- insert how to do format HDDs and interval control via GUI
Manually installing new HDDs
If there are any issues with the GUI while attempting to format HDDs or run the interval control test, see the Manual Maintenance page.