Difference between revisions of "DFNEXT PC and video only"
(Created page with "First connect the main DFNEXT camera (DFNEXT040), and give it 5 minutes after boot. Then connect: - video camera straight to USB3 port - HDMI cable to portable screen - ether...") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
First connect the main DFNEXT camera (DFNEXT040), and give it 5 minutes after boot. | First connect the main DFNEXT camera (DFNEXT040), and give it 5 minutes after boot. | ||
| + | |||
Then connect: | Then connect: | ||
| − | + | ||
| − | + | * video camera straight to USB3 port | |
| − | + | * HDMI cable to portable screen | |
| − | + | * ethernet cable to outside port of the main DFNEXT on bottom port. | |
| − | + | * keyboard and mouse in grey USB leads. | |
| + | * finally, power straight on PC board. | ||
| + | |||
| + | |||
To focus, follow instructions [[Focusing_the_video_lens|here]]. | To focus, follow instructions [[Focusing_the_video_lens|here]]. | ||
| + | |||
| + | |||
| + | Point it East (270 deg azimuth), and about 55 degrees up. | ||
| + | |||
| + | Or use JAXA app (aim is to point it at the 90-100km point on the trajectory. | ||
| + | |||
| + | |||
| + | If possible, align the long edge of the sensor with the trajectory to capture more of it. | ||
Latest revision as of 01:40, 4 December 2020
First connect the main DFNEXT camera (DFNEXT040), and give it 5 minutes after boot.
Then connect:
- video camera straight to USB3 port
- HDMI cable to portable screen
- ethernet cable to outside port of the main DFNEXT on bottom port.
- keyboard and mouse in grey USB leads.
- finally, power straight on PC board.
To focus, follow instructions here.
Point it East (270 deg azimuth), and about 55 degrees up.
Or use JAXA app (aim is to point it at the 90-100km point on the trajectory.
If possible, align the long edge of the sensor with the trajectory to capture more of it.
